PLASTICS ENGINEERING COMPANY SHEBOYGAN, WISCONSIN 53082-0758 U.S.A.

3518 LAKESHORE ROAD POST OFFICE BOX 758 PHONE 920-458-2121 FAX 920-458-1923

Compression Molding Guidelines for Cold Powder Molding of

PLENCO Single Stage Phenolic & Two Stage Phenolic Molding Compounds

Parameter	Suggested Press Settings
Mold Temperatures	165° - 182°C (330° - 360°F)
Mold Close Time	3 - 8 Seconds
Clamp Tonnage	27.6 - 41.4 MPa (2 - 3 Tons/in^2) Of Projected Part Area

Additional Technical Information

• A clean, highly polished, chrome plated mold is recommended. Use a mold release such as Carnauba Wax, being careful to coat the entire surface. After several shots wipe off the excessive mold release using a clean, soft cloth.
• Each time a mold using a Single Stage compound has sat idle, it is highly recommended that the mold is started with a Two Stage general purpose product for the first several shots and then switched to the Single Stage compound. This is done to minimize problems with part and flash sticking.

Common Molding Problems	Potential Solutions
Blistering	Increase mold temperature Increase cure time
Gas Burns	Slow mold close time Check for blocked vent(s)
Short Parts	Increase charge weight Lower mold temperature
Sticking Parts	Increase mold temperature Increase cure time

The listed parameters are suggested for use as a guide when setting up a compression molding machine for molding Plenco Thermoset materials. These parameters are for your evaluation and may or may not be compatible for all mold designs, press configurations, and material rheology. Please feel free to call Plenco and a Plenco Technical Service Representative will be happy to assist you.
Revised 10-9-01